SHIM 1420534 - Caterpillar

Secure hose assembly (10) to the engine with the following hardware: one 8S-0948 Clip (11), two 8M-2773 Clips (12) and two 1S-6420 Clips (13) .
Illustration 28 g00754764
Install one 9X-7381 O-Ring Seal (9) on 137-7260 Hose As (14). Connect hose (14) to the small fitting on the back of the air conditioner.
Install one 9X-7380 O-Ring Seal (15) to 137-7260 Hose As (14). Connect hose (14) to the bottom port on the condenser.
Use one 5K-8451 Clip (16) and three 7K-1181 Cable Straps (17) to secure hose (14) and hose (10) .
Illustration 29 g00754590
Install eleven 7X-0579 Hard Washers (19) and eleven 8T-4908 Bolts (18) to the top of the air conditioner group inside the cab.
Illustration 30 g00754776
Use the following hardware to connect 106-8704 Arc Suppressor (20) to the compressor.
One 3S-2093 Cable Strap (21)
One 9U-2277 Clip As (22)
One 5P-4116 Hard Washer (23)
One 8T-4189 Bolt (24)
Use one 9X-7378 O-Ring Seal (25) in order to connect the 114-5333 Pressure Switch (26) to the compressor. Tighten the pressure switch to a torque of 8 1.5 N m (70 13 lb in).
Secure the wire from pressure switch (26) with one 7K-1181 Cable Strap (17) .
Illustration 31 g00754784
Illustration 32 g00754786
Connect 130-5890 Air Conditioner Harness As (27) to the compressor with the following hardware:
Two 3S-2093 Cable Straps (21)
One 4P-7581 Clip (28)
Two 9U-2277 Clip As (22)
Four 8T-4121 Hard Washers (29)
Two 8T-4133 Nuts (30)
Two 8T-4186 Bolts (31)
One 4P-7581 Clip (28)
Illustration 33 g00763467
Secure the engine wiring harness to the right side of the engine by using one 5P-9085 Clip (32) and existing hardware.Charge the System
Evacuate the air conditioner system. Charge the air conditioner system. The correct charge is 1.5 kg (3.3 lb). Refer to Service Manual, SENR5664, "Air Conditioning and Heating Systems with R-134a Refrigerant" for the correct procedure. Refer to Special Publication, NEDG5065, "Air Conditioning Tools" for the correct tools.Installation of the Seat
Table 7
Required Parts    
Item     Qty     Part Number     Description    
1     1     110-6393     Instruction Plate    
Install the seat. See the Operator's Station Disassembly and Assembly, "Seat and Seat Belts".
Illustration 34 g00754799
Stamp 110-6393 Instruction Plate (1) with 1.5 kg (3.3 lb). Attach 110-6393 Instruction Plate to the front of the base of seat (A) .
Separate the steering frame lock. Refer to the Disassembly and Assembly, "Steering Frame Lock - Seperate and Connect".