SHIM 3396699 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury can result from the sudden release of high pressure oil.Be sure the engine has been shut off for a minimum of five minutes to be sure that the accumulator pressure is zero.The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or cap from the top of the accumulator. A purge screw at the bottom of the accumulator can be used to release the pressure that is left in the system.
Note: Put identification marks on the hose assembly and plug the hose assembly. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Note: The ride control accumulator is located inside the front loader frame.
Illustration 1 g00403984
Disconnect hose assembly (1) .
Remove two bolts (2) .
Illustration 2 g00403985
Remove two bolts (3) .
Illustration 3 g00403987
Attach Tooling (A) to ride control accumulator (4). Use a suitable hoist and lifting slings in order to remove ride control accumulator (4). The weight of ride control accumulator (4) is 40 kg (88 lb).Installation Procedure
Illustration 4 g00403987
Attach Tooling (A) to ride control accumulator (4). Use a suitable hoist and lifting slings in order to install ride control accumulator (4). The weight of ride control accumulator (4) is 40 kg (88 lb).
Illustration 5 g00403985
Install two bolts (3) .
Illustration 6 g00403984
Install two bolts (2) .
Connect hose assembly (1) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".