SHIM PACK 3711197 - Caterpillar

Table 1
Calibration Submodes For Tracked Pavers    
Submode Number     Paving Status     Description    
c01     X (1)     Left Conveyor Ratio Dial Full Clockwise    
c02     X     Left Conveyor Ratio Dial Full CCW (2)    
c03     X     Right Conveyor Ratio Dial Full Clockwise    
c04     X     Left Conveyor Ratio Dial Full CCW    
c05     X     Left Material Height Sensor Full OFF    
c06     X     Left Material Height Sensor Full ON    
c07     X     Right Material Height Sensor Full OFF    
c08     X     Right Material Height Sensor Full ON    
c09     X     Left Material Height Dial Full Clockwise    
c10     X     Left Material Height Dial Full CCW    
c11     X     Right Material Height Dial Full Clockwise    
c12     X     Right Material Height Dial Full CCW    
c13     ON     Left Pump Flow Solenoid Initial Current    
c14     ON     Right Pump Flow Solenoid Initial Current    
c15     ON     Left Conveyor Bypass Solenoid Initial Current    
c16     ON     Right Conveyor Bypass Solenoid Initial Current    
c17 (3)     ON     Left Pump Flow Solenoid Maximum Current    
c18 (3)     ON     Right Pump Flow Solenoid Maximum Current    
( 1 ) Does not matter.
( 2 ) Counter-clockwise.
( 3 ) Only available for AP650 and BG225C machines.Note: Submodes c13 thru c18 require that the paving status is ON. THE CONVEYORS AND AUGERS WILL OPERATE DURING THESE CALIBRATIONS. The following machine conditions are required:
The engine speed at high idle.
The parking brake is ON.
The propel switch in the PAVE position (LOW position for the AP1000B and BG260C).
The propel lever in the FORWARD position.
The conveyor, auger and feeder mode switches in AUTO.
Illustration 1 g01117645
(1) Conveyor ECM mode switch (2) Conveyor ECM display mode switch (3) Conveyor ECM display areaNote: The calibration submodes are used to perform actual tests and adjustments. Only enter these submodes when performing the procedures as described.The calibration submodes can be accessed by using the service switches (1, 2). Calibration mode 2 must be entered first. Then the calibration submodes are accessible. The ECM provides normal operation until calibration mode 2 is entered.Entering Calibration Mode 2
Illustration 2 g01112014
ECM display showing calibration mode "2"
Press and hold the ECM mode switch (1) in the SCROLL position.
Release the switch when "- 2 -" is showing in the display area.The ECM now enters the calibration mode. Submode c01 will automatically be shown on the ECM display.Entering a Submode
In order to enter a submode, first enter the calibration mode 2. The system automaticaly enters the first submode c01. The number showing on the ECM display is the submode that is currently entered. Refer to Table 1 calibration submode chart for a list of the availble submodes.
Illustration 3 g01112015
ECM display showing calibration submode "c01"The submodes are used to perform calibration procedures. Perform the following steps in order to access the submodes.
Press and hold the display mode switch