SHIM 3831328 - Caterpillar

Illustration 1 g02726783
Illustration 2 g02726782
Table 1
Specification for 262-4393 Flywheel Housing Gp
Item Qty Part Specification Description
Front face of the flywheel housing and rear face of the cylinder block must be free of oil, fuel, water, gasket adhesive, and any other contaminants during assembly. Apply ultra blue Loctite 587 to seal the joints between the cylinder block, flywheel housing, and engine oil pan.
Before assembly, apply ultra blue Loctite 587 to the locations (4). After assembly, apply ultra blue Loctite 587 to the locations (5).
1 8 165-3929 Bolt Use the following procedure to tighten the bolts of the flywheel housing:
1.Tighten bolt 1 through bolt 9 in the numerical sequence as shown in the Illustration 2 to 100 20 N m (75 15 lb ft)
2. Tighten bolt 10 through bolt 24 in the numerical sequence as shown in the Illustration 2 to 40 10 N m (30 7 lb ft) in the numerical sequence.
3. Again, tighten bolt 1 through bolt 9 in the numerical sequence as shown in the Illustration 2 to 135 20 N m (100 15 lb ft) in the numerical sequence.
4. Again, tighten bolt 10 through bolt 24 in the numerical sequence as shown in the Illustration 2 to 55 10 N m (41 7 lb ft) in the numerical sequence.
2 7 165-3931 Bolt
3 9 5J-5793 Bolt