SHIM 4697904 - Caterpillar

Illustration 5 g01785473To avoid engine damage, use only Caterpillar radial seal air filters as replacement filters. Refer to the following topics for correct replacement instructions:
Operation and Maintenance Manual, "Engine Air Filter Primary Element - Clean/Replace"
Operation and Maintenance Manual, "Engine Air Filter Secondary Element - Replace"Required Engine Oil (4)This message is located on the engine oil filler tube.
Illustration 6 g02176761Refer to Operation and Maintenance Manual, "Lubricant Viscosities".Wood Chip or Waste Handling Arrangement (5)If equipped, additional message (5) is located on the radiator guard next to the clean out opening and cover.
Illustration 7 g01352487The engine must be shut off before any maintenance is performed. Use a wand in order to clean debris from the fan and baffle assembly.Product Link (6)This message is located beneath the left window inside the cab.
Illustration 8 g01418953The Product Link System is a communication device that transmits information regarding the machine back to Caterpillar and Caterpillar dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the CAT data link can be sent to the receiving station. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.The Product Link is also available in cellular format.Refer to Operation and Maintenance Manual, "Product Link" for more information.Reference: See Operation and Maintenance Manual, "Maintenance Interval Schedule" for all maintenance recommendations.FCC Compliance (7)This message is located on the product link module on the back right ROPS of the cab.
Illustration 9 g01213010Consult your Cat dealer with any questions that concern the operation of the Product Link in a specific country.Diesel Fuel Requirements (8) One of the following messages is located next to the fuel filler cap.
Illustration 10 g02157153
Illustration 11 g02052934Use only Ultralow Sulfur Diesel (ULSD) fuel.The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability and will damage emissions control systems and/or shorten the service interval. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.Note: In Europe, diesel fuels that are identified as meeting "European Standard EN590:2004" requirements for ≤ 10 ppm sulfur fuel (a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur are typically referred to as “sulfur-free”. These fuels generally meet Cat requirements for ULSD fuel.Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information.
Illustration 12 g03405673"No Weld/No Drill" (9)This message is located on the outside left ROPS post.
Illustration 13 g01212169Diesel Exhaust Fluid Fill (10)This message is located of the left side of the machine near the diesel exhaust fluid tank.
Illustration 14 g03146379Wait to Disconnect Lamp (11)Do not turn