SHIM 5M2000 - Caterpillar

Illustration 1 g03820494
Table 1
Specification for 383-1762 Water Pump Gp    
Item    Qty    Part    Specification Description    
1     11     0S-1585 Bolt     Torque to
27 4 N m (239 35 lb in).    
2     12     0S-1587 Bolt     Torque to
27 4 N m (239 35 lb in).    
3     2     6V-7701 O-Ring Seal     Before assembly, lightly lubricate the bore with 5P-3975 Rubber Lubricant.    
Illustration 2 g03820470
Table 2
Item    Qty    Part    Specification Description    
4     1     292-5982 Face Seal Gp     Before assembly, lightly lubricate the bore with 5P-3975 Rubber Lubricant.    
Use the 8T-3034 Water Pump Seal Driver and hand pressure in order to install the water seal (5) and the ring together in the pump housing bore. Ensure that the polished face of the ring is toward the groove of the seal assembly.
Before assembly, remove the spring from the seal.
Put clean water on the seal assembly as the only lubrication for assembly. Do not get any grease or oil on the seal faces.
Do not stretch the rubber of the seal assembly at installation. If the seal is stretched, the service life is shortened.
Use the 8T-3034 Water Pump Seal Driver and hand pressure to install the seal assembly on the pump shaft until the seal face makes light contact with the smooth face of the ring.
The seal assembly must rotate with the water pump shaft. Do not use any lubricant (except clean water) that will reduce the friction between the seal and the shaft.
Install the carbon seal assembly spring.
6     1     134-5958 O-Ring Seal     Before assembly, lightly lubricate the bore with 5P-3975 Rubber Lubricant.    
7     4     9S-8007 Plug     Torque to
8 1 N m (71 9 lb in).    
C     -     -     Diameter of the 441-9266 Shaft at the seat area of the carbon seal assembly is
44.45 0.02 mm (1.750 0.001 inch).    
D     -     -     Diameter of the 441-9266 Shaft at the location of the lip type seal is
49.20 0.20 mm (1.937 0.008 inch).    
E     -     -     Diameter of the 441-9266 Shaft is
64.85 0.02 mm (2.553 0.001 inch).    
F     -     -     Diameter of the 441-9266 Shaft at the support end is
88.878 0.013 mm (3.4991 0.0005 inch).    
8     1     3B-2968 Bolt     Before assembly, apply black Loctite Graphite-50 to the washer face and threads.
No antiseize allowed on impeller face.    
G     1     1W-2828 Thrust Washer     Thickness is
11.75 0.15 mm (0.463 0.006 inch).    
Width of groove in the impeller shaft is
12.00 0.05 mm (0.472 0.002 inch).
Illustration 3 g03820472
Table 3
Item    Qty    Part    Specification Description    
H     -     -     Dimension between surface of pump housing to 188-0449