SHIM STOCK 5P1515 - Caterpillar

1. Disconnect wire harness (1) at the electrical connection. 2. Remove three bolts (2), the washers, three lugs (3), and housing (5) from plate assembly (4). 3. Remove bolt (6), the washer, and rod end (8) from link assembly (7). 4. Remove two bolts (9), the washers, and rotary position sensor (10) from housing (5). The following steps are for the installation of the sensor (ripper rotary position).5. Make sure all components of the ripper rotary position sensor are clean of dirt and foreign material prior to installation.6. Check all components for wear or damage and replace if necessary.7. Install rotary position sensor (10), two bolts (9), and the washers from housing (5).8. Install rod end (8), bolt (6), and the washer to link assembly (7).9. Install three lugs (3), housing (5), three bolts (2), and the washers to plate assembly (4).10. Connect wire harness (1) at the electrical connection.11. For the correct calibration procedures refer to the topic "System Calibrations" in the 24H Motor Grader, Transmission Electronic Control System and Hydraulic Calibrations manual, SENR1423.