SHIM (1.6 MM THICK) 6T8644 - Caterpillar

Sliding the Seat
Illustration 1 g01092709
In order to move the seat to the opposite side of the machine, push down on lever (1) which is located below the seat.
Pull up on tee handle (2) .
Slide the seat to the desired side of the machine.
Release tee handle (2). Lock the tee handle into the locking hole. This will lock the seat into position. Do not operate the machine when the tee handle is not locked into one of the locking holes.Note: There are locking holes on both sides of the machine.
Lift lever (1) in order to keep the seat from rocking.Sliding the Platform
Illustration 2 g01096773
In order to slide the platform, loosen the two bolts.
Slide the platform to the desired location.Note: The handrails for the platform may need to be turned outward in order to slide the platform to the desired location. Refer to "Handrails for the Operator Platform" for the procedure on adjusting the handrails.
Tighten the bolts in order to lock the platform into position. Do not operate the machine when the platform is not locked into position.Handrails for the Operator Platform
Illustration 3 g01096777
The handrails for the platform can be turned outward in order to allow the operator to slide the platform. In order to adjust the handrail, perform the following procedure.
Remove locking pin (5) that is located near the bottom of the handrail.
Turn the handrail to the desired location.
Install locking pin (5) .The handrails may also be used in order to mount optional accessories. In order to mount an accessory, slide the accessory into the holder on the handrail (4). Turn knob (3) in order to lock the accessory in place.