SHIM PACK 7G2325 - Caterpillar

Illustration 1 g01421050
Control panel (1) Advisor II display (2) Keypad for the Advisor II (3) "DESIRED SPEED" potentiometer (4) Mode control switch (5) "MANUAL PRELUBE" switch and "PRELUBE ACTIVE" indicator (6) "EMERGENCY STOP" button (7) "ENGINE ON" indicator (8) "ACTIVE ALARM" indicator (9) "ENGINE FAILURE" indicatorThe features of the control panel are described below.Advisor II
Advisor II is a device which enables the operator to monitor engine operation. The Advisor II receives information from the Electronic Control Module (ECM). The device cannot be used for programming. A screen display and a keypad provide the interface for the operator.When the control panel is powered up, the screen becomes active. To view the options for the display, press the "?" key. Table 1 lists the menu.
Table 1
Menu    
(1)     Status Information    
(2)     Detonation Levels    
(3)     Ignition Timing    
(4)     Filtered Burn Times    
(5)     Unfiltered Burn Times    
(6)     Exhaust Temperatures    
(7)     Turbo Temperatures    
(8)     Events and Diagnostics    
(9)     Display Setup    Keypad
Illustration 2 g00799615
KeypadTo select an option, press the number on the keypad that corresponds to the selection. To exit the option, press the "?" key or any of the numbered keys. It is not necessary to return to the menu in order to select a different option. When you press a different numbered key, the corresponding option is displayed."DESIRED SPEED" Potentiometer
The "DESIRED SPEED" potentiometer allows the operator to adjust the desired engine speed. This is achieved by providing a 0 to 5 volt input to the ECM.Engine Control Switch
The engine control switch has four positions: "AUTO", "START", "STOP" and "OFF/RESET""AUTO" - When the engine control switch is in the "AUTO" position (12 o'clock), the system is configured for remote operation. When the remote start/stop relay closes, the prelube system will operate. When the pressure of the prelube system is sufficient, the engine will start. When the remote start/stop relay opens, the engine will shut off. If the cool down cycle is programmed, the engine will operate for the cool down period before the engine stops. The cool down cycle can be programmed for a 0 to 30 minute period."START" - When the engine control switch is turned to the "START" position (3 o'clock), the prelube system will operate. When the pressure of the prelube system is sufficient, the engine will start. The engine will operate until the ECM receives a shutdown signal.The following conditions cause a shutdown signal:
The remote start/stop relay opens when the engine control switch is in the "AUTO" position.
The engine control switch is turned to the "STOP" position.
The engine control switch is turned to the "OFF/RESET" position.
The "EMERGENCY STOP" button is pressed.
An undesirable operating condition is sensed and an engine shutdown is initiated by the ECM."STOP" - When the engine control switch is turned to the "STOP" position (6 o'clock), the engine will shut off. If the cool down cycle is programmed, the engine will operate for the cool down period before the engine