SHIM 7T3183 - Caterpillar

Marine Engine:
C-12 MARINE (S/N: K1M1-UP; 9HP1-UP)
C12 MARINE (S/N: NFL1-UP; C1Z1-UP)
Engine Storage Information
Caterpillar recommends an ongoing process of identification and monitoring of engines that are located at dealerships, customers, OEM's and storage facilities of the dealers that may require storage and storage preservation. If long-term storage of the engines is required, procedures and recommendations exist, in order to prepare Caterpillar engines for storage up to one year.The engine should be stored in a controlled environment prior to delivery. The storage environment should not have extreme variations in temperature or humidity. The storage environment should prevent exposure to ultraviolet light. Proper storage procedures are required in order to maintain the service life of the product.Utilize the practices and procedures that are described in Special Instruction, SEHS9031, "Storage Procedure for Caterpillar Products" to ensure the optimum health and durability of the product. Also utilize the procedures described in the Operation and Maintenance Manual, SEBU7599 for storage of engines regarding engine belts.Engine Storage
Loosen all belts prior to storage.Removal from Storage
Check the condition of the fan and alternator belts. Replace the belts, if necessary. Refer to this Operation and Maintenance Manual, "Belts - Inspect/Adjust/Replace" or refer to this Operation and Maintenance Manual, "Belts - Inspect/Replace" for the correct procedure.Belts - Inspect/Adjust/Replace
Currently a Clavis belt tension gauge is used at the factory to measure the tension on the V-belts that are listed below.Inspect the alternator belt and any accessory belts for wear and for cracking. Replace the belts if the belts are not in good condition. To check the belt tension, apply 110 N (25 lb) of force midway between the pulleys. A correctly adjusted belt will deflect 13 mm to 19 mm (0.50 inch to 0.75 inch) .Slippage of loose belts can reduce the efficiency of the driven components. Vibration of loose belts can cause unnecessary wear on the following components:
Belts
Pulleys
BearingsVerification of Procedures of Storage
Although verification of storage is not required in order to maintain the warranty, this fact does not eliminate the need for proper storage procedures. In the case of a claim for warranty, Caterpillar may require documentation which proves that the recommended storage procedures were followed. Engines that are damaged by faulty storage or preservation will not be considered to have a factory defect in material or workmanship.