SHIM 7Y1479 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Actuator Control Linkage - Replace
Barring Device - Lubricate
Engine Air Cleaner Element (Single Element) - Clean/Replace
Engine Air Precleaner - Clean
Overhaul Considerations
Valve Stem Projection - Measure/Record
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Control Panel - Inspect
Cooling System Coolant Level - Check
Driven Equipment - Inspect/Replace/Lubricate
Electrohydraulic System - Inspect
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Fuel Filter Differential Pressure - Check
Walk-Around Inspection
Every 250 Service Hours
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Every 1000 Service Hours
Actuator Control Linkage - Lubricate
Cooling System Coolant Sample (Level 1) - Obtain
Every 2000 Service Hours
Aftercooler Condensation - Drain
Cooling System Coolant Sample (Level 2) - Obtain
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Ignition System Spark Plugs - Check/Adjust
Valve Stem Projection - Measure/Record
Every 4000 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Every 5000 Service Hours
Combustion Sensor - Clean/Inspect/Replace
Cooling System Level Switch - Inspect
Crankcase Blowby - Measure/Record
Cylinder Pressure - Measure/Record
Electrohydraulic System - Check/Adjust
Electrohydraulic System Oil - Change
Electrohydraulic System Oil Filter - Change
Engine Oil - Change
Engine Oil Filter - Change
Exhaust Bypass - Recondition
Ignition System Spark Plugs - Replace
Inlet Air System - Inspect
Gas Shutoff Valve - Inspect
Every 6000 Service Hours
Prechamber Check Valves - Clean
Every 8000 Service Hours
Air Starting Motor Lines Screen - Clean
Air Starting Motor Lubricator Bowl - Clean
Belts - Inspect/Adjust/Replace
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Crankcase Breather - Clean
Engine Mounts - Check
Engine Protective Devices - Check
Engine Protective Device Connections - Inspect
Hoses and Clamps - Inspect/Replace
Inlet Gas Manifold and Piping - Inspect/Replace