SHIM .030 in.(.762 mm) thick 9D4475 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Engine Air Cleaner Element - Replace
Overhaul Considerations
Valve Stem Projection - Measure/Record
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Control Panel - Inspect
Cooling System Coolant Level - Check
Driven Equipment - Inspect/Replace/Lubricate
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Clean
Engine Oil Level - Check
Fuel System Fuel Filter Differential Pressure - Check
Instrument Panel - Inspect
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Every 250 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Every 500 Service Hours
Cooling System Coolant Analysis (Level I) - Obtain
Every 750 Service Hours
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Crankcase Breather - Clean
Engine Oil and Filter - Change
Exhaust Piping - Inspect
Hoses and Clamps - Inspect/Replace
Ignition System Spark Plugs - Inspect/Replace
Ignition System Timing - Check/Adjust
Inlet Air System - Inspect
Radiator - Clean
Initial 750 Service Hours
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Gas Pressure Regulator - Check
Valve Stem Projection - Measure/Record
Initial 1500 Service Hours
Valve Stem Projection - Measure/Record
Every 1500 Service Hours
Actuator Control Linkage - Lubricate
Carburetor Air/Fuel Ratio - Check/Adjust
Crankcase Blowby - Measure/Record
Cylinder Pressure - Measure/Record
Engine Protective Devices - Check
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Gas Pressure Regulator - Check
Speed Sensor - Clean/Inspect
Every Year
Cooling System Coolant Analysis (Level II) - Obtain
Every 3000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Alternator - Inspect
Driven Equipment - Check
Engine Mounts - Check
Ignition System Transformer Resistance - Test
Starting Motor - Inspect