SHIM PACK 9T2011 - Caterpillar

Operation Description:This procedure should be performed when the machine is in the Economy Mode and the ECM will not activate the Power ModeTest Step 1. ATTEMPT TO ACTIVATE THE POWER MODEPress the Power Mode Button on the SSP until the corresponding LED indicator light turns ON steady.Expected Result:The LED for the power mode turns ON and does not flash.Results:
OK - The LED for the power mode turns ON and does not flash. Proceed to Test Step 2.
NOT OK - The LED for the Power Mode flashes and the LED for the Economy Mode is ON steady. Proceed to Test Step 4.Test Step 2. CHECK THAT THE POWER MODE IS ACTIVECheck if the machine has full power.Results:
YES - The machine has full power. The problem is not present. Resume normal operation.STOP
NO - The machine does not have full power. Proceed to Test Step 3.Test Step 3. CHECK FOR ACTIVE DIAGNOSTIC CODESCheck for any active CID 1629 (Main Pump Power Shift Pressure Solenoid) diagnostic code or CID 1630 (Swing Pump Power Shift Pressure Solenoid) diagnostic code. Results:
YES - An active CID 1629 (Main Pump Power Shift Pressure Solenoid) diagnostic code or an active CID 1630 (Swing Pump Power Shift Pressure Solenoid) diagnostic code is present. Repair: The ECM will not activate the Power Mode with one of these diagnostic codes active. Proceed to the troubleshooting procedure in this manual for the active CID 1629 or CID 1630 diagnostic code. When the code is cleared, the ECM will activate the Power Mode.STOP
NO - An active CID 1629 (Main Pump Power Shift Pressure Solenoid) diagnostic code or an active CID 1630 (Swing Pump Power Shift Pressure Solenoid) diagnostic code is not present.Repair: The electrical components on the machine are most likely not causing the problem. Refer to Troubleshooting, KENR5429, "C4.4 and C6.6 Engines For Caterpillar Built Machines" for troubleshooting the engine performance.STOPTest Step 4. CHECK THE MACHINE CONDITIONSThe following machine conditions will cause the ECM to activate the Economy Power Mode regardless of the operator mode selection.
When the ECM has activated a diagnostic code for one of the power shift solenoids, the ECM will activate the Economy Mode.
When the Limp Home Mode switch is in the ON position, the ECM will activate the Economy Mode and implement hydraulic will be disabled.
When an error event EID 0561 (Low Hydraulic Oil Temperature) is activated or if the Hydraulic Oil Temperature Sensor has an active fault, the ECM will activate the Economy Mode.
When an error event EID 0878 (High Hydraulic Oil Temperature) is activated, the ECM will activate the Economy Mode.
When an error event EID 0236 (Hydraulic Oil Filter Plugged) is activated or an error event EID 0391 (Air Filter Plugged) is activated, the ECM will activate the Economy Mode.
When the Hydraulic Modulation Function is enabled, the ECM will activate the Economy Mode for the swing pump.Expected Result:One or more of the listed machine conditions is present.Results:
YES - One or more of the listed machine conditions is present.Repair: The ECM will not activate the Power