SHOE-TRACK 1V0557 - Caterpillar

Assembly Procedure
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Illustration 1 g01012709
Install O-ring seal (15) onto the pump.
Illustration 2 g01012708
Install seal (13) and seal (14) onto plate (12).
Illustration 3 g01012706
Install plate (12) onto pump (6).
Illustration 4 g01012705
Install gear (10) and gear (11) onto pump (6).
Illustration 5 g01012704
Install seal (8) and seal (9) onto plate (7).
Illustration 6 g01012703
Install plate (7) onto pump (6).
Illustration 7 g01012702
Install housing (4) onto pump (6).
Illustration 8 g01012701
Install O-ring seal (5) onto cover (3).
Illustration 9 g01012699
Position cover (3) onto housing (4).
Install bolts (2) into cover (3).
Illustration 10 g01012697
Install clip (1) onto the shaft. End By:
Install the gear pump. Refer to Disassembly and Assembly, "Gear Pump (Conveyor System Charge) - Install".