SHOE-TRACK 2352534 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not remove the priority valve while the engine is hot. Hot oil can cause burns.
Illustration 1 g00609688
Replace the O-ring seals (8) on the front housing.
Illustration 2 g00609676
Illustration 3 g00609681
This is an Illustration of a priority valve that is not covered by tubes and lines.
Replace the priority valve on the front housing.
Replace six bolts (7).
Replace the clamp bolt (4).
Replace the bolts in order to connect the tube (7).
Replace the tube (1) on the priority valve.
Replace the clamp bolt (2).
Pull the elbow assembly downward in order to allow clearance for the priority valve to be replaced. Lubricate the seals before installation.
Connect the elbow (3).
Connect the tube (5).
Close the drain valve on the oil filters.
Check the engine oil level. Refer to the Operation And Maintenance Manual.