SHOE-TRACK 3261136 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that all components are clean and free from wear and damage. If necessary, replace any components that are worn or damaged.
Illustration 1 g03421330
If necessary, install filler cap (14) onto tank (16). On some application the filler cap may be of a different type. Refer to Original Equipment Manufactures (OEM) for the correct removal procedure.
Position bracket (11) onto tank (16).
Install bolts (15) onto bracket (11). Tighten the bolts to a torque of 4 N m (35 lb in).
Illustration 2 g03421327
Position bracket (12) onto bracket (11).
Install bolts (13) to bracket (12). Tighten the bolts to a torque of 4 N m (35 lb in).
Illustration 3 g03421235
Install diesel exhaust fluid pump (10). Refer to Disassembly and Assembly, "Diesel Exhaust Fluid Pump - Remove and Install" for the correct procedure.
Position harness assembly (9) onto the bracket.
Install new cable straps (7) and new cable straps (8) from harness assembly (9). Ensure that all the cable straps are installed in the original position. Note: Ensure that the cable straps meet the OEM specifications.
Illustration 4 g03421223
Position relay (3) onto the bracket. Install bolt (1) to the relay. Tighten the bolt to a torque of 4 N m (35 lb in).
Position relay (4) onto the bracket. Install bolt (2) to the relay. Tighten the bolt to a torque of 4 N m (35 lb in).
Connect harness assembly (6) to relay (4).
Connect harness assembly (5) to relay (3).
Turn the battery disconnect switch to the ON position. End By:
Install the voltage load protection module. Refer to Disassembly and Assembly, "Voltage Load Protection Module - Remove and Install" for the correct procedure.
Install the electronic control (Diesel Exhaust Fluid). Refer to Disassembly and Assembly, "Electronic Control (Diesel Exhaust Fluid) - Remove and Install" for the correct procedure.
Install the manifold (DEF heater). Refer to Disassembly and Assembly, "Manifold (DEF Heater) - Remove and Install" for the correct procedure.
Install the solenoid valve (DEF heater coolant). Refer to Disassembly and Assembly, "Solenoid Valve (DEF Heater Coolant) - Remove and Install" for the correct procedure.
Install the diesel exhaust fluid lines. Refer to Disassembly and Assembly, "Diesel Exhaust Fluid Lines - Remove and Install" for the correct procedure.