SHOE 3Y2931 - Caterpillar

g01282847
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
No Step (13)Safety message (13) is located on both of the blade angle cylinders for a VPAT blade, if equipped.
g01370910
Falling Hazard - Area may be wet and slippery. Do not step on angle blade cylinders. Serious injury or death could occur from a fall.
Do Not Operate (14) (Engine)Safety message (14) is located inside the engine compartment.
g01370904
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in serious injury or death.
Do Not Operate (15) (Winch)Safety message (15) is located on the right side of the machine on the vertical wall of the winch frame, if equipped.
g01055734
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
No Step (16)Safety message (16) is located on the right side of the machine on the vertical wall of the winch frame, if equipped.
g01370910
Do not use this surface as a step or platform. This surface may not support additional weight or may be slippery. Serious injury or death could occur from a fall.
LaserIf your machine is equipped with the AccuGrade - Laser System, this safety message is located on each leg of the tripod for the laser.
g01282876
Movement of the transmitter could cause unexpected blade movement. Death or serious injury could occur. Turn off the transmitter before you move the transmitter or before you adjust the transmitter.
Blade and MastWhen you use the AccuGrade - Laser System, this safety message is located on the rear of each mast at eye level from the ground.
g01282878
To prevent possible personal injury during installation and removal of the laser receivers, lower the mast to the minimum height and use an approved access system to reach the mounting locations of the laser receivers at the top of the mast. Do not climb on the blade.