SHOE 8K8305 - Caterpillar

Equipment ID
The Equipment ID parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field.Engine Serial Number
Program the Engine Serial Number to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM.(FLS) Full Load Setting
Full Load Setting is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information ratings plate. Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required.(FTS) Full Torque Setting
Full Torque Setting is similar to Full Load Setting. Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required.Either Solenoid Configuration
The Either Solenoid Configuration allows the operation of this feature to be enabled or disabled.Engine Fan Control
The Engine Fan Control parameter enables automatic control of fan speed. Fan speed is based on engine operating temperature. Engine Warm-up Elevated Idle Feature Enable Status
The Engine Warm-up Elevated Idle Feature Enable Status allows the operation of this feature to be enabled or disabled.Engine Warm-up Elevated Idle Delay Time
The Engine Warm-up Elevated Idle Delay Time allows adjustment of the delay time before elevated idle becomes active.(PTO) Engine Speed Setting
The (PTO) Engine Speed Setting parameter allows an intermediate speed to be programmed.Engine Governor Primary Mode Configuration
The Engine Governor Primary Mode Configuration parameter allows the engine speed to be "speed controlled" or " torque controlled". Factory passwords are required.Total Tattletale
The Total Tattletale parameter counts the number of changes to system parameters.Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Product ID 8 Characters 0XX00000 None
Equipment ID 17 Characters Not Programmed None
Engine Serial Number 8 Characters 0XX00000 Factory
FLS -127 to +127 Not Programmed Factory
FTS -127 to +127 Not Programmed Factory
Either Solenoid Configuration Continuous Flow
None Continuous Flow None
Engine Fan Control Enabled
Disabled Enabled None
Engine Warm-up Elevated Idle Enabled
Disabled Disabled None
Engine Warm-up Elevated Idle Delay Time Three Minutes to Ten Minutes Five Minutes None
(PTO) Engine Speed Setting Low Idle to High Idle 1500 rpm None
Engine Governor Primary Mode Configuration Speed Control
Torque Control Speed Control Factory
Total Tattletale 0 to 65535 Read Only Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
"Equipment ID"
"Engine Serial Number"
"ECM Serial Number"
"Software Group Part Number"
"Software Group Release Date"
"FLS"
"FTS"
"Total Tattletale"
Table 3
Information From Engine Information Plate
Engine Serial Number
Full Load Setting
(for new ECM)
Full Torque Setting
(for new ECM)
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.