SHROUD GP-RADIATOR 1192833 - Caterpillar

Machine Stopping
Park on a level surface. If it is necessary to park on a grade, block the machine securely.Use the propel lever to slow the machine. The foot operated secondary brake may be used when additional braking is required.
1. Move propel lever to the neutral position.2. Engage parking brake.3. Move all light switches (if equipped) to OFF.4. Lower rotor until ground contact is made.Engine Stopping
Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear on the engine components.Refer to the following stopping procedure to allow the engine to cool, and to prevent excessive temperatures in the turbocharger center housing which could cause oil coking problems.
1. With the machine parked, move the throttle switch to reduce the engine speed and run the engine for five minutes at low idle. 2. Turn the engine start switch key to OFF. Remove the key.Leaving the Machine
1. Use steps (1) and handholds (2), use both hands and face the machine, when dismounting.2. Inspect the engine compartment for debris. Clean out any debris and paper to avoid a fire.3. If the machine is being parked for an extended period (overnight, etc.), turn the disconnect switch key to OFF and remove the key.4. Install vandalism protection covers (3) and locks.