SHROUD AS-FAN 1458156 - Caterpillar

Illustration 12 g00038790
This safety message is positioned on the outside rear corner of the machine.
No clearance for person in this area during operation. Severe injury or death from impalement could occur. Stay away from the work tool while it is in operation.
Lift Eyes Can Fail (10)
Illustration 13 g00100728
This safety message is located on the top of the hydraulic tank and on top of the fuel tank.
LIFT EYES OR TANK CAN FAIL WHEN LIFTING TANK CONTAINING FLUIDS RESULTING IN POSSIBLE PERSONAL INJURY. DRAIN TANK OF ALL FLUIDS BEFORE LIFTING.
Relieve Hydraulic Tank Pressure (11)
Illustration 14 g00912819
This safety message is located on top of the hydraulic tank.
HYDRAULIC TANKRELIEVE TANK PRESSURE WITH ENGINE OFF BY REMOVING CAP SLOWLY TO PREVENT BURNS FROM HOT OIL.
Operator Protective Guard (12)
Illustration 15 g00939192
These safety messages are located on the left side of the top portion of the falling object guard structure.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Crush Points (13)
Illustration 16 g00104210
This safety message is positioned inside the cab riser compartment access door and to the right side of the cab riser compartment access door. This safety message is positioned on the front of the machine below the cab riser.
Stand away from the cab when the cab is being tilted for transportation or for repair. There is no clearance for a person in this area. Severe injury or death from crushing could occur.
No Ether (14)
Illustration 17 g00912750
This safety message is positioned on the cover of the intake duct of the air cleaner.
Since this machine is equipped with an air inlet heater, ether should not be used for starting. Using ether can create explosions or fires that can cause personal injury or death. Follow the starting procedure in the Operation and Maintenance Manual.
Improper Connections for Jump Start Cables (15)
Illustration 18 g00913047
This safety message is positioned on the right side of the circuit breaker panel.
IMPROPER JUMPER CABLE CONNECTIONS CAN CAUSE EXPLOSION RESULTING IN PERSONAL INJURY.BATTERIES MAY BE LOCATED IN SEPARATE COMPARTMENTS. WHEN USING JUMPER CABLES, ALWAYS CONNECT POSITIVE (+) CABLE TO POSITIVE (+) TERMINAL OF BATTERY CONNECTED TO STARTER SOLENOID AND NEGATIVE (-) CABLE FROM EXTERNAL SOURCE TO STARTER NEGATIVE (-) TERMINAL (IF MACHINE NOT EQUIPPED WITH STARTER NEGATIVE TERMINAL, CONNECT TO ENGINE BLOCK.) FOLLOW PROCEDURE IN THE OPERATION MANUAL.