SHROUD 1494543 - Caterpillar

Illustration 1 g01110247
Typical example (1) Torque for the 3 bolts ... 30 4 N m (22 3 lb ft) (2) Use the following information to correctly install the speed sensors.
Align the top of the gear tooth with the center of the hole.
Insert the sensor until firm contact with the tooth is made.
After contact is made unscrew the sensor 1/2 1/8 of a turn.
Torque the retaining nut on the sensor to 25 5 N m (18.5 3.5 lb ft). (3) Torque for the retaining nut for the harness plug ... 184 14 N m (136 10 lb ft)Note: Do not allow unprotected wires to rub on other parts. Ensure that the wires are not too tight when the wires come out of connections. (4) Torque for the temperature sensor ... 20 3 N m (15 2 lb ft) (5) 230-3166 Relief Valve cracking pressure ... 76 15 kPa (11.0 2.2 psi) (6) Torque for the 6 bolts ... 30 4 N m (22 3 lb ft) (7) Torque for the 10 bolts ... 30 4 N m (22 3 lb ft) (8) To install the adapter, remove the nipple from the modulating valve and tighten the adapter to 14 4 N m (10 3 lb ft). Reinstall the nipple and tighten the nipple to 14 4 N m (10 3 lb ft).