SHROUD- 5137270 - Caterpillar

Hot hydraulic oil under high pressure can remain in the components of the hydraulic system or the power train system after the engine has been stopped. The uncontrolled release of the hydraulic oil can cause sudden machine movement and can also result in the following conditions:
Burns
The penetration of body tissue
Other personal injury
DeathIf hydraulic oil penetrates body tissue, the injury must be treated immediately by a doctor who is familiar with this type of injury. Use a board or a piece of cardboard to check for a hydraulic oil leak. Make sure that all of the attachments have been lowered to the ground and that all trapped pressure has been released from the hydraulic system and the power train system. Also, make sure that the hydraulic oil is cool before the removal of any components or lines. Remove the hydraulic oil filler cap only when the engine is stopped and the filler cap is cool enough to touch with your bare hand.
Sudden movement or accidental starting of the machine can cause personal injury or death to persons on or near the machine.To prevent personal injury or death, perform the following:Park the machine on a smooth, level surface.Lower the work tool to the ground and engage the parking brake.Stop the engine and remove the key.Block the wheels and install the steering frame lock.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Specifications
Table 1
Pilot and Brake Pressure - High Idle
3500 kPa (510 psi)
Introduction
Pilot and brake pressure is provided by the implement pump. Pilot pressure is controlled by a pressure reducing valve in the pilot manifold which is located inboard of the backhoe implement valve.Required Tools
Illustration 1 g02571852
Tooling (A) 198-4240 Digital Pressure Indicator Gp
Table 2
Required Tools
Tool Item Qty Part No Description
A 198-4240 Digital Pressure Indicator Gp
A1 1 198-4234 Digital Indicator
A2 1 198-4239 Pressure Sensor Gp
(0 kPa to 41,368 kPa (0 psi to 6,000 psi))
A3 1 198-4236 Adapter Cable As Check Preparation
Move the machine to a smooth, horizontal location that is away from operating machines and away from personnel.
Place the transmission direction in the NEUTRAL position.
Engage the parking brake.
Lower the loader and backhoe to the ground.
Stop the engine.
Relieve the pressure in the hydraulic system.Reference: Refer to the Service Manual module Testing and Adjusting, "System Pressure - Release" for the machine that is being serviced.Check Procedure
Illustration 2 g06012734
Underside view of machine.
(1) Pilot Manifold
(2) Pilot Pressure Test Port
Install tooling (A) to test port (2).
Start the machine.
Increase the engine speed to high idle.
Observe the pilot pressure on tooling (A), the pressure should be 3500 kPa (510 psi).
Lower the engine speed to low idle.
Stop the engine.
Remove tooling (A).Check complete.