SHROUD-LH 9V2279 - Caterpillar

Start By:a. remove drive axle shafts (front)b. remove center drive shaft1. Remove the front drive shaft. See the topic "Remove & Install Front Drive Shaft & Carrier Bearing" in this module.2. Lift the front of the machine until the front tires are approximately 229 mm (9.0 in) off the floor. Put wood blocks under the front tires to hold the front end up.3. Put wood blocks behind the rear tires of the machine so it can not roll backwards. 4. Raise the lift arms assembly until tooling (A) can be installed under the lift arm assembly as shown. Install tooling (A) as shown. Be sure all the weight of the lift arm assembly and bucket is on tooling (A).
View From Under Machine5. Remove the four bolts and washers and two plates (1) that hold brake tube assemblies (2) in position. Disconnected brake tube assembly (2) from the wheel assembly.
View From Under Machine6. Remove two bolts (3)