SILENCER 3669089 - Caterpillar

High Pressure Gas (15)
Illustration 18 g01374065This safety message is located on the accumulator in the right back compartment.
Pressurized System!Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas pre-charge must be removed from the accumulator as instructed by the service manual before servicing the accumulator or any accumulator component.Failure to follow the instructions and warnings could result in personal injury or death.Only use dry nitrogen gas to recharge accumulators. See your Cat dealer for special equipment and detailed information for accumulator service and charging.
Refer to Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped" for further information.Pressurized System (16)
Illustration 19 g01371640This safety message is located on top of the radiator, next to the filler cap.
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check" for further information.Crushing Hazard (17)
Illustration 20 g01374060This safety message is located on both sides of the back end of the machine.
Machine swings. Stay back. Crushing hazard could cause serious injury or death.
Jump Start Cables (18)
Illustration 21 g01370909This safety message is located inside the left front compartment.
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Refer to Operation and Maintenance Manual, "Engine Starting with Jump Start Cables" for further information.High Pressure Cylinder (19)
Illustration 22 g01076729This safety message is positioned on the track adjuster on both sides of the machine.
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for the adjustment procedure.Crushing Hazard (20)This safety message is located on both sides of the stick.
Illustration 23 g01385579
A crushing hazard exists when the stick and boom are in motion and when the machine is being used in object handling applications. Failure to stay clear of the stick and boom when the machine is in operation can result in personal injury or death. Stay clear of the stick and boom when the machine is in operation.