SKID PACK AR 1551704 - Caterpillar

Use a suitable lifting device to position fender assembly (35D) according to the following Illustrations: Illustration 141, Illustration142and Illustration 143. Use the following items to install fender assembly (35D):
Eight bolts (35K)
18 washers (35G)
Ten bolts (35H)Note: The weight of the fender assembly is 150 kg (330 lb).
Illustration 144 g01380450
Left side of machine is shown.
The tires have been removed for viewing purposes.
(35D) Fender assembly
(35E) Plate
(35G) Washers
(35N) Baffle
(35P) Bolts
Attach baffle (35N) to the tandem according to Illustration 144. Use the following items to attach baffle (35N):
One plate (35E)
12 washers (35G)
12 bolts (35P)
Illustration 145 g01381174
Left side of machine is shown.
(35R) Handrail
(35S) Bolt
(35T) Plate
Position handrail (35R) according to Illustration 145. Use the following items to install handrail (35R):
Four plates (35T)
Two bolts (35S)
Repeat for the front of the tandem.
Repeat Step 1 through Step 8 for the other side of the machine.Toe-In Adjustment Procedure for the Front Wheels
Before service work is begun, park the machine on a hard level surface. Block the wheels of the machine so unexpected movement will not occur. Unexpected movement of the machine can cause personal injury or death.
Note: The rear tires must be blocked and the parking brake must be set before you begin the toe-in adjustment procedure for the front wheels.
Illustration 146 g00800436
View of the installed wheel lean bolt
Note: The wheel lean bolt must be installed before you begin the toe-in adjustment procedure.
Illustration 147 g01387432
(36) Wheel lean bolt
(37) Nut
(38) Clamp
(39) Rod
Raise the front end of the machine with the moldboard by extending the lift cylinders.
Mark the centerline of both of the front tires. Measure the dimension and record the dimension.
Rotate the tire around 180 degrees. Measure the dimension and record the dimension.
The toe-in is correct if the measurement in Step 2 equals the measurement in Step 3. The toe-in requires adjustment if the difference is greater than 3.18 mm (0.125 inch).
To adjust the toe-in, loosen nuts (37) on clamps (38). Rotate rod (39) in the direction that is needed to achieve the correct toe-in for the front wheels. When the toe-in adjustment is correct, orient the tie rod clamps according to Illustration 147. Tighten nuts (37).
Repeat Step 2 through Step 4 to verify the toe-in adjustment.
Lower the front end of the machine to the ground.
Remove wheel lean bolt (36).Check for Faults in the Monitoring System
Reference: Refer to Systems Operation, RENR9034, "120M, 12M, 140M, 14M, 160M, 16M, and 24M Motor Graders Monitoring System" for the proper procedure for clearing all fault codes that are inactive. Correct all active fault codes before you proceed with the commissioning procedure.Commissioning Procedure
Reference: Refer to Service Manual, UENR3481, "24M Motor Grader" for the appropriate checking procedures.Reference: Refer to Service Manual, RENR9060, "24M Motor Grader" for the appropriate checking procedures.The pages that follow are a list of assembly checks and systems checks that are recommended. Please do all the checks and verify that all the systems function properly.Use the Service Manual and use the Operation and Maintenance Manual to correct any system malfunctions before the machine is delivered.Make copies of the check procedure. Mail the copies to the following address:Caterpillar