SKIRT-CONSOLE-RH 1138686 - Caterpillar

Removal Procedure
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information.Refer to Systems Operation, Testing and Adjusting Manual, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on wires and on all tube assemblies for installation purposes. Plug all hose assemblies and tube assemblies. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Turn the fuel supply to the OFF position.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g01269003
Typical example
Disconnect harness assembly (3) from electric priming pump (4).
Disconnect plastic tube assembly (1) and plastic tube assembly (2) from electric priming pump (4). Note: If the tube assemblies have quick fit connections, ensure that the connections are clean before the tube assemblies and the electric priming pump are plugged.
Remove bolts (5) from electric priming pump (4).
Remove electric priming pump (4) from the mounting bracket. Installation Procedure
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorized personnel that have the correct training.Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information.Refer to Systems Operation, Testing and Adjusting Manual, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Ensure that the electric priming pump is clean and free from wear or damage. If necessary, replace the electric priming pump.
Illustration 2 g01269003
Typical example
Position electric priming pump (4) on the mounting bracket. Install bolts (5) to the electric priming pump.
Tighten bolts (5) to a torque of 9 N m (79 lb in).
Remove all plugs from plastic tube assembly (1), plastic tube assembly (2) and electric priming pump (4). Connect plastic tube assembly (1) and plastic tube assembly (2) to electric priming pump (4). Note: If the tube assemblies have quick fit connections, ensure that the connections are clean before the tube assemblies are connected.
Connect harness assembly (3) to electric priming pump (4).
Turn the fuel supply to the ON position.
Turn the battery disconnect switch to the ON position.
Remove the air from the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".