SLEEVE 1881113 - Caterpillar

Illustration 1 g01327514
Illustration 2 g01327506
View A-A
Illustration 3 g00521238
View B-B
Note: Use black Loctite Graphite-50 in order to lubricate the components. Lubricate the taper and the threads of the ball studs. Also, lubricate the washer face of the nuts. (1) Ball studs that are located on the steering cylinders (2) 8X-6731 ShimThickness ... 1.0 mm (0.04 inch)Clearance between the top side of the steering arm and the frame ... 0.7 0.6 mm (0.03 0.02 inch) (3) Ball studs that are located on the steering linkage (4) Install this seal dry. (5) NutsNuts (5) are located on the ball studs that are located on the steering cylinders (1) and on the ball studs that are located on the steering linkage (3).Quantity ... 8Torque ... 1360 N m (1003 lb ft)Note: If the cotter pin for nuts (5) will not assemble, tighten nuts (5) in order to allow the cotter pin to assemble. (6) LocknutsQuantity ... 4Torque ... 183 N m (135 lb ft)Note: Tighten locknuts (6) after performing the alignment procedure in the Steering System Testing and Adjusting, "Front Wheel - Align".