SLEEVE 1889927 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00820013
Remove drain plugs (5) and washers (3) from engine oil pan (2). Drain the engine oil into a suitable container for storage or disposal.
Remove bolts (4) for engine oil pan (2) .
Remove engine oil pan (2) from the engine.
Remove the remaining gasket material (1) from engine oil pan (2) and the cylinder block.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g00820013
Clean all surfaces thoroughly. Inspect the condition of gasket (1). Replace the gasket, if necessary.
Position gasket (1) and engine oil pan (2) on the engine.
Install bolts (4) for engine oil pan (2) .For 3011C Engines, tighten the bolts for the engine oil pan to a torque of 6 N m (53 lb in).For 3013C Engines and 3024C Engines, tighten the bolts for the engine oil pan to a torque of 11 N m (97 lb in).
Install drain plugs (5) and washers (3) to oil pan (2). Tighten the drain plugs for the engine oil pan to a torque of 35 N m (26 lb ft).Note: When a drain plug is removed, install a new O-ring.
Fill the engine oil pan to the correct level that is indicated on the engine oil level gauge. Refer to Operation and Maintenance Manual, "Refill Capacities" for more information.