SLEEVE 1P0558 - Caterpillar

Agricultural Tractor AllArticulated Truck AllAsphalt Paver AllBackhoe Loader AllChallenger AllCold Planer AllCombine AllCompact Wheel Loader AllEarthmoving Compactor AllExcavator AllIntegrated Toolcarrier AllLandfill Compactor AllLoad Haul Dump AllMini Hydraulic Excavator AllMotor Grader AllMulti Terrain Loader AllOff-Highway Truck/Tractor AllPaving Compactor AllPaving Compactor Vibratory Compactor ALLSkid Steer Loader AllSoil Compactor AllTelehandler AllTrack Feller Buncher CaterpillarTrack-Type Loader AllTrack-Type Skidder AllTrack-Type Tractor AllWheel Dozer AllWheel Loader AllWheel Skidder AllWheel Tractor-Scraper AllIntroduction
This Special Instruction will provide the parts and procedures to install the Pro Product Link PL641 or PL631 radio on machines with a PL522 or PL523Note: Installation of a PL542 will be covered later.Reference: Special Instruction, REHS9111, "Installation Procedure for the Pro Product Link™ PL641 and PL631 Systems".Reference: Special Instruction, REHS7428, "VIMS 3G Software Installation Guide For Certain Cat® Product Using VIMSpc 2011A and VIMSpc 2013A".Reference: Systems Operation, RENR6293, "VIMSpc Software".Reference: Systems Operation, UENR0769, "VIMSTM 3G".Reference: Systems OperationTroubleshootingTesting and Adjusting, M0079294, "Product Link® PL542 Systems".Reference: Special Instruction, M0077632, "Installation Procedure for the Product LinkTM PL542 Systems".Important Safety Information
Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe.Ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance, or repair procedures used.
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Personal injury or death can result when voiding this certification.Structural damage, an overturn, modification, alteration, or improper repair can impair the Rollover Protective Structure's (ROPS) protection capability thereby voiding this certification.Do not drill holes in the ROPS. Do not weld on the ROPS unless welding is specified in the procedure. Place welds only at the locations that are specified in the procedure.To avoid possible weakening of this ROPS, consult a Caterpillar dealer before