SLEEVE 2060127 - Caterpillar

Illustration 9 g00584046
Attach a suitable lifting sling around the rear section of auxiliary drive shaft (16). Secure the suitable lifting sling to a hoist. Remove 12 bolts (17) and the washers in order to separate the rear section of auxiliary drive shaft (16) from torsional coupler (18). Separate auxiliary drive shaft (16) from torsional coupler (18) .
Slide the rear section of auxiliary drive shaft (16) forward. Secure the rear section of auxiliary drive shaft (16) in the center bracket assembly on the engine end frame.
Illustration 10 g00584047
Disconnect two hose assemblies (19) and (20) from the manifold on top of the rear pump drive.
Illustration 11 g00584049
Attach a suitable lifting sling around torsional coupler (18). Secure the suitable lifting sling to a hoist. Remove torsional coupler (18) from the rear pump drive. The weight of torsional coupler (18) is 66 kg (145 lb).
Illustration 12 g00584051
Disconnect electrical harness (21) at the electrical connection. Remove the bolt and the washer that secures clamp (22) to the transmission. Position clamp (22) and wire harness (23) for the removal of the auxiliary drive shaft.
Remove the bolt and the washer that secures hose clamp (24) to the transmission. Position hose clamp (24) and hose assembly (25) for the removal of the auxiliary drive shaft.
Illustration 13 g00584053
Attach the suitable lifting sling on the rear section of auxiliary drive shaft (16) to a hoist.
Remove the rear section of auxiliary drive shaft (16) from the center bracket assembly on the engine end frame. The weight of the rear section of auxiliary drive shaft (16) is 84 kg (185 lb).
Illustration 14 g00584055
Remove four bolts (26) that secure spider (27) to the rear section of auxiliary drive shaft (16). Discard four bolts (26). Do not reuse bolts. Remove spider (27) from the rear section of auxiliary drive shaft ( 16) .
Repeat the procedure for each end of the front section of the auxiliary drive shaft.
Illustration 15 g00584057
Remove O-ring seal (28) from yoke (11) .
Illustration 16 g00584060
Remove dirt guard (29) from yoke (11) .
Illustration 17 g00584063
Use a hammer and a punch in order to remove lip seal (30) from bearing retainer (13) .
Illustration 18 g00584066
Remove fitting (31) and the O-ring seal from bearing retainer (13) .
Illustration 19 g00584077
Remove O-ring seal (32) from bearing cage (33) .
Illustration 20 g00584069
Place bearing cage (33) on wood blocks, as shown. Use a hammer and a brass punch in order to remove roller bearing (34) from bearing cage (33) .
Illustration 21 g00584071
Use a hammer and a punch in order to remove lip seal (35) from bearing cage (33) .