SLEEVE 2660404 - Caterpillar

The engine start switch must be in the ON position and the engine must be running in order to maintain electrical functions and hydraulic functions. This procedure must be followed in order to prevent serious machine damage.
Illustration 1 g00406959
Turn the battery disconnect switch to the ON position.
Make sure that the reset buttons for the circuit breakers remain depressed. Refer to Operation and Maintenance Manual, "Circuit Breakers - Reset".
Illustration 2 g00543871
Move the hydraulic lockout control to the LOCKED position.This machine is equipped with an engine neutral start system. The system only allows the engine to start when the hydraulic lockout control is in the LOCKED position.
Move the joystick controls to the HOLD position.
Illustration 3 g00103355
(1) Engine start switch (2) Engine speed dial
Turn engine start switch (1) to the ON position.
Leave the engine start switch in the ON position for more than two seconds in order to activate the prestart monitoring function. Refer to Operation and Maintenance Manual, "Monitoring System" for more information on the prestart monitoring function.If the fluid level is too low, add the corresponding fluid to the specified level. Add the fluid before you start the engine.
Turn engine speed dial (2) to speed position "5" or speed position "6".
Do not crank the engine for more than 30 seconds. If the engine does not start, allow the starter to cool for two minutes before cranking again. The engine start switch must be turned to the OFF position before trying to restart.
Turn engine start switch (1) to the START position.
Release the engine start switch key after the engine starts.