SLEEVE 2B5004 - Caterpillar

(1) Torque for impeller nut ... 2.25 N m (20 lb ft)Tighten nut an additional ... 110° Do not bend or add stress to the shaft when nut is tightened.(2) Torque for bolts holding back plate ... 8.5 to 10.2 N m (75 to 90 lb in)(3) Put 5P3931 Anti-Seize Compound on threads and tighten bolts holding compressor housing to center section to ... 13.0 1.7 N m (115 15 lb in)(4) Put 5P3931 Anti-Seize Compound on threads and tighten bolts holding turbine housing to center section to ... 13.0 1.7 N m (115 15 lb in)(5) Put 5P3931 Anti-Seize Compound on threads and tighten nuts that hold turbocharger to the manifold to ... 55 5 N m (40 4 lb in)(6) Endplay for shaft:Minimum permissible endplay ... 0.03 mm (.001 in)Maximum permissible endplay ... 0.10 mm (.004 in)(7) Radial play for shaft:Minimum permissible radial play ... 0.08 mm (.003 in)Maximum permissible radial play ... 0.15 mm (.006 in)(8) Bore in the bearing ... 10.185 to 10.196 mm (.4010 to .4014 in)Diameter of surface on shaft (journal) for the bearing ... 10.152 to 10.160 mm (.3997 to .4000 in)(9) Bore in housing ... 15.799 to 15.806 mm (.6220 to .6223 in)Outside diameter of the bearing ... 15.702 to 15.715 mm (.6182 to .6187 in)(10) Clearance between end of oil seal ring ... 0.20 to 0.38 mm (.008 to .015 in)Diameter of bore for oil seal ring ... 18.01 to 18.06 mm (.709 to .711 in)