SLEEVE 2G1314 - Caterpillar

From the "SERVICE" screen, the two menu options that configure the machine's options for tool control follow: "CONFIGURATION" and "TOOL PROGRAM". Each procedure is described below.Procedure for accessing "CONFIGURATION" menu
From the "SERVICE" screen, use the down key (6) to scroll through the menu options.
When the "CONFIGURATION" option is highlighted, press the OK key (8) .
From the "CONFIGURATION" screen, use the down key (6) to scroll through the menu options.
When the "TOOL INSTALLATION" option is highlighted, press the OK key (8) .
From the "TOOL INSTALLATION" screen, use the down key (6) to scroll through the menu options. When the desired option is highlighted, press the OK key (8) .
"TOOL INSTALLATION" parameters that can be changed are located in Table 2. To change the parameters, highlight the desired parameter and press the OK key (8) .
Use the up key (1) and use the down key (6) in order to change the value. Press the OK key (8) in order to save settings.
Table 2
"SERVICE" / "CONFIGURATION" / "TOOL INSTALLATION"    
Display    Description    
"MACHINE APPLICATION"     Configuration of the application for the machine    
"ATCH ECM INSTALLATION"     Installation status of the attachment controller    
"FLOW LIMIT VALVE"     Installation status of the main pump's control valve for the limitation of flow    
"ATCH VALVE #1"     Configuration of the number 1 attachment valve    
"ATCH VALVE #3"     Configuration of the number 3 attachment valve    
"FLOW COMBINE"     Configuration of the number 1 combiner valve    
"VARIABLE RELIEF #1"     Configuration of the number 1 variable relief valve    
"VARIABLE RELIEF #2"     Configuration of the number 2 variable relief valve    
"TOOL LOAD PRES SENSOR"     Installation status of the F2 valve's pressure sensor for load sensing    
Press the home key (3) in order to exit the service mode, or back out using the cancel key (7) , until the "SERVICE" screen appears. Refer to Illustration 2.Procedure for accessing "TOOL PROGRAM" menu
From the "SERVICE" screen, use the down key (6) to scroll through the menu options.
When the "TOOL PROGRAM" option is highlighted, press the OK key (8) .
From the "TOOL PROGRAM" screen, use the down key (6) to scroll through the menu options.
When the desired item is highlighted press the OK key (8) .
After pressing the OK key (8) , the "TOOL #??" screen should appear. "TOOL #??" parameters that can be changed are located in Table 3. To change the parameters, highlight the desired parameter and press the OK key (8) .
Use the up key (1) and use the down key (6) in order to change the value. Press the OK key (8) in order to save settings.
Table 3
"SERVICE" / "TOOL PROGRAM" / "TOOL #??"    
Display    Description    
"NAME"     Name of the tool    
"MAX DIAL"     Maximum position of the dial for the throttle    
"MIN DIAL"     Minimum position of the dial for the throttle    
"UNDERSPEED ENABLE"     Enabling of the underspeed option    
"COMBINER ENABLE"     Combined two