SLEEVE 2S5718 - Caterpillar

the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Water Separator - Check/Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Every Week
Jacket Water Heater - Check
PM Level 1 - Every 17 700 km (11 000 miles) or 4150 L (1100 US gal) of Fuel or 250 Service Hours or 6 Months
Coolant Sample (Level 1) - Obtain
Initial 250 Service Hours
Engine Oil and Filter - Change
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 250 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Fuel Tank Water and Sediment - Drain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 500 Service Hours or 6 Months
Engine Protective Devices - Check
Every 2000 Service Hours
Alternator - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Coolant Extender (ELC) - Add
Coolant Temperature Regulator - Replace
Every 8000 Service Hours or 3 Years
Driven Equipment - Check
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Every 14 400 L (3750 US gal) of Fuel or 250 Service Hours or 1 Year
Battery Electrolyte Level - Check
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Fuel System Primary Filter - Replace
Fuel System Secondary Filter - Replace
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours
Aftercooler Core - Clean/Test
Every 170 400 L (45 000 US gal) of Fuel or 3000 Service Hours
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fan Drive Bearing - Lubricate
Fuel Injector - Check
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations
Overhaul
Fan Drive Bearing - Replace