SLEEVE 3723328 - Caterpillar

4N8505 SHOWN(1) Tighten nut for drive gear to a torque of ... 205 7 N m (150 5 lb. ft.)(2) Tighten pulley studs to a torque of ... 25 4 N m (20 3 lb. ft.)1N3270, 7N8750 & 7N8881 Auxiliary Drive Groups:
7N8750 SHOWN(1) Tighten nut to a torque of ... 290 10 N m (210 7 lb. ft.) Lightly hit nut with hammer and again tighten to ... 290 10 N m (210 7 lb. ft.)(2) O-ring seal. Put a small amount of clean engine oil or glycerine in the bore for lubrication at assembly.(3) Tighten nut to a torque of ... 108 7 N m (80 5 lb.ft.) Tighten more if needed to make an alignment of the slots and bend tab of the lock on nut.(4) Tighten the studs to a torque of ... 30 5 N m (22 4 lb.ft.)(5) Distance bearing is from end of housing ... 6.6 0.5 mm (.26 .02 in.)(6) Seal. Install seal with the lip toward the bearing as shown. Put a small amount of clean engine oil on the lip of the seal as lubricant for assembly.