AVSPARE.COM
parts catalog

SLEEVE-O-RING-YM 3967268 - Caterpillar



3967268 SLEEVE-O-RING-YM Caterpillar parts SLEEVE
Rating:
69
Alternative (cross code) number:
CA3967268
396-7268
3967268
Caterpillar 3967268 SLEEVE-O-RING-YM
Weight: 1 pounds 0 kg.

Buy SLEEVE-O-RING-YM 3967268 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


New seals must be preloaded before they are installed to prevent them from being damaged or broken. There is a correct method to preload new seal rings prior to installation. Place your hands on each end of the seal ring, and pull (wind) the ends several inches past each other or until they almost make contact. Use care to keep the ring shaped like a circle. This will make an even bend (or ring “set”) all around the ring. When the seal ring is in the groove of the carrier, the ends must butt together lightly. Do not bend the seal ring. This does not make an even bend all the way around the ring.Do not attempt to use this method to preload a used seal ring. Also, do not use this procedure for cast iron seal rings. This will cause used or cast iron rings to break.
Illustration 7 g00746876
Heat the bearing (16) to a maximum temperature of 120°C (248°F) and install the bearing on hub assembly (7). The bearing must be seated squarely on the hub assembly after the bearing has cooled.
Install three rings (15) on hub assembly (7).
Illustration 8 g00746875
Install bearing (14) in housing (13).
Illustration 9 g00746980
Fasten a suitable lifting device and Tooling (A) to housing (13). Lower the housing into position on hub assembly (7).
Illustration 10 g00746873
Install ring (12) on hub assembly (7).
Illustration 11 g00746982
Start with a plate and install plates (20) and discs (21). Alternate the plates and discs.
Illustration 12 g00746983
Install plate (18) and bolts (17) on housing (13).
Illustration 13 g00746984
Install sleeve bearing (9) in hub assembly (7).
Illustration 14 g00746872
Illustration 15 g00746985
Install seals (10) and (11) in piston (8).
Put clean oil on the seals. Install piston (8) in hub assembly (7).
Illustration 16 g00746986
Install input hub (4).
Illustration 17 g00746987
Start with a plate and install clutch plates (5) and friction discs (6).
Illustration 18 g00746867
Illustration 19 g00746866
Install sleeve bearing (3) in plate (2).
Put plate (2) in position on the housing, and install bolts (1). End By:
Connect the final drive, steering clutches, and brakes. Refer to Disassembly and Assembly, "Final Drive, Steering Clutch, and Brakes - Connect".


Parts sleeve Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.