SLEEVE 3T1100 - Caterpillar

Connecting Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     3    
B     1P-2420     Transmission Repair Stand     1    
C     1U-9200     Lever Puller Hoist     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01370713
Attach Tooling (C) and a suitable lifting device to Tooling (A) . The weight of torque converter (21) is approximately 204 kg (450 lb). Position torque converter (21) and install bolt (12A) and bolts (22) onto transmission (23) to a torque of 100 20 N m (73 14 lb ft).
Illustration 2 g01370563
Illustration 3 g01370559
Install bolt (20) to a torque of 285 15 N m (210 11 lb ft). Install plug (19) to a torque of 285 15 N m (210 11 lb ft).
If equipped, install the rear PTO shaft.
Illustration 4 g01459190
Note: Bolt (12A) was installed earlier.
Position pump (12) and install bolts (11) to a torque of 55 10 N m (40 7 lb ft). Position housing (17) and install bolts (18) to a torque of 55 10 N m (40 7 lb ft). Install oil level sensor (14) . Tighten the bolts for oil level sensor (14) to a torque of 14 3 N m (10 2 lb ft). Connect harness assembly (13) . Install tube assemblies (15) and (16) .
Illustration 5 g01229810
Position oil pan (10) and install bolts (9) to a torque of 55 10 N m (40 7 lb ft).
Illustration 6 g01229809
Install screen (8) and magnetic filter (7) .
Illustration 7 g01229803
Position cover (6) and install bolts (5) to a torque of 28 7 N m (20 5 lb ft).
Illustration 8 g01357551
Connect harness assembly (4) .
Illustration 9 g01357387
Connect harness assemblies (2) and (3) .
Illustration 10 g01229798
Use Tooling (A) and a suitable lifting device in order to remove the transmission and torque converter (1) from Tooling (B) . The weight of transmission and torque converter (1) is approximately 680 kg (1500 lb).