SLEEVE 4598635 - Caterpillar

Removal Procedure
Start By:
Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00540847
Remove O-ring seal (1), water seals (3) and water directors (4) from spacer plate (2) .
Illustration 2 g00540857
Do not damage the dowels as the spacer plate is removed.
Remove spacer plate (2) from the cylinder head.
Illustration 3 g00540895
Remove O-ring seal (6) and spacer plate gasket (5) from the cylinder head.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Thoroughly clean the mating surfaces between the spacer plate and the cylinder block.
Illustration 4 g00540895
Install new spacer plate gasket (5) and new O-ring seal (6) .Note: If the dowels in the cylinder block have been removed for any reason, the overall height of the installation is 16.0 5.0 mm (.63 .20 inch).
Illustration 5 g00540857
Note: Both surfaces of the spacer plate, spacer plate gasket and the top of the cylinder block must be clean and dry. Do not use any gasket adhesive or other substances on these surfaces.
Install spacer plate (2) on the cylinder head.
Illustration 6 g00540847
Install a new O-ring seal (1). Install new water seals (3). Install new water directors (4) .
Check the cylinder liner projection. Refer to Disassembly and Assembly, "Cylinder Liner - Install".End By: Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".