SLEEVE-ON 5P9296 LANYARD 5P7958 - Caterpillar

Data Links
The EMCP 3 has up to three different data links:
Primary data link
Accessory data link
System control and data acquisition (SCADA) data link Note: The EMCP 3.1 has one primary data link. The EMCP 3.2 and EMCP 3.3 have one primary data link, one accessory data link, and one SCADA data link.Primary Data Link - J1939 (CAN 1)
The primary data link is used for local communication among modules associated with a single generator set. Examples of modules include the electronic control module (ECM) for the engine (EUI engines only), Cat digital voltage regulator (CDVR), and the thermocouple module. On MUI engines, the engine sensors are wired directly to the EMCP 3. The primary data link utilizes the Society Of Automotive Engineers (SAE) J1939 protocol and requires controller area network (CAN) hardware running at 250 k bits per second.The primary data link supports appropriate SAE J1939 broadcast parameter group numbers (PGN) and suspect parameter numbers (SPN) for engine and generator set data.Accessory Data Link - J1939 (CAN 2)
The accessory data link is used for local communication among modules associated with a single generator set. Examples of modules include annunciators, RTD modules, and discrete input output modules. Accessory data link utilizes the Society Of Automotive Engineers (SAE) J1939 protocol and requires CAN hardware running at 250 k bits per second.The accessory data link supports appropriate SAE J1939 broadcast parameter group numbers (PGN) and suspect parameter numbers (SPN) for engine and generator set data.SCADA Data Link - Modbus RS-485
The SCADA data link is used for communication with a System Control And Data Acquisition (SCADA) system.The SCADA data link uses the Modbus protocol with an RS-485 half duplex hardware layer operating at a minimum of 2.4 k bits per second. All data items are accessed as Modbus registers. Data that is less than 16 bits occupies a single register. Larger data occupies consecutive registers in order to allow access using single request.The SCADA data link is a master/slave data link. The SCADA controller or customer software will be the master and the generator set controls will be slaves on the Data Link.The SCADA controller can connect directly to the generator set control. Also, the SCADA controller may be connected remotely through a modem using an RS-485 to RS-232 converter. Passwords levels are used in order to restrict access to the generator set control.Each generator set control on the SCADA data link has a unique Modbus address. A set point is available to select the address for the generator set control.In order to use a modem connection to the SCADA data link, the modem must be pre-configured with all necessary communication parameters. Also, the modem must be set to answer automatically. No modem handshaking or control is performed by the EMCP 3.Refer to the Application and Installation Guide, LEBE5255 for more detailed information about the SCADA data link.