SLEEVE- 6V2097 - Caterpillar

Installation Procedure
Note: Check all of the O-ring seals and the components for wear or for damage. Replace the components, if necessary. Lubricate all of the O-ring seals lightly with the lubricant that is being sealed. Clean all of the components with a cloth that is free of loose material (lint).
Illustration 1 g00642128
Position a suitable lifting sling (not shown) around gear pump (2). Secure the suitable lifting sling to a hoist.
Install two 3/8 in - 16 NC guide bolts in the torque converter housing.
Install the gasket on gear pump (2).
Position gear pump (2) on the torque converter housing. Remove the guide bolts and install nine bolts (5) that hold gear pump (2) in place.
Connect hose assembly (6) to gear pump (2).
Connect two hose assemblies (3) to gear pump (4) (if equipped). Note: These hose assemblies are only installed on machines that are equipped with oil cooled brakes for the front wheels.
Connect three hose assemblies (1) to gear pump (2).
Fill the hoist, torque converter, and brake hydraulic tank with oil to the correct level. Refer to the Operation and Maintenance Manual, "Hoist, Torque Converter and Brake Tank Oil - Change". The capacity of the tank is 250 L (66 US gal). End By:
Remove the body retaining pins. Refer to Disassembly and Assembly, "Pin (Body Retaining) - Remove and Install" for the Machine System.