SLEEVE 8I3637 - Caterpillar

Illustration 10 g01452528
(19) 9M-7958 Hose Clamp (20) 308-3566 Fumes Disposal Hose (21) 160-8500 Nut (22) 297-3218 Clip (23) 9M-1974 Hard Washer (24) 3S-2093 Cable Strap
Install hose (20) that connects the breather to the fitting on the side cover. Install hose clamps (19) in order to secure the hose. Install clip (22), washer (23), nut (21) and cable strap (24) .
If the breather on the side cover was removed, reinstall the breather. If the fuel filter was removed, reinstall the fuel filter. Reinstall any fuel lines that were removed.
Reinstall the pipe for the air to air aftercooler. Reinstall the exhaust elbow and the muffler.Required Parts
Table 2
Required Parts    
Part Number     Description     Quantity    
249-5523     Side Cover     1    
250-5785     Gasket     1    
6V-2317     Bolt     6    
9M-1974     Washer     9    
4P-5918     Clip     3    
5C-7261     Nut     3    
273-2838     Spacer Sleeve     13    
288-9179     Valve Mechanism Cover Gp     1    
099-3649     Bolt     13    
8T-4224     Washer     13    
227-4531     Engine Oil Filler Cap As     1    
204-4444     Breather As     1    
3E-4091     Elbow     1    
5P-4961     Clamp     2    
9M-7958     Hose Clamp     2    
092-6629     Connector     1    
249-6673     Elbow     1    
297-3218     Clip     1    
308-3566     Fumes Disposal Hose     1    
160-8500     Nut     1    
164-7900     Adapter     1    
2M-9780     O-Ring Seal     1    
3J-7354     O-Ring Seal     1    
3S-2093     Cable Strap     2    
5P-1425     Hose     15 cm (5.9 inch)    
5C-7261     Nut     2    Reducing the Oil Level
The following procedure will outline the process in order to reduce the oil level in the engine. Reducing the oil level will improve the loss of oil through the air breather when the machine is operating on sloped terrain. Monitor the oil level daily. Monitoring the oil daily will ensure that the oil level does not become too low. Use selected oil sample in order to measure the quality of the oil.
Park the machine on a level surface.
Verify that the oil level is at the "Full" label on the oil gauge. If the oil is not at the correct level, remove oil or add oil until the oil level is at the correct level.
Use a container that is able to measure liquid volume.
Drain 2.0 L (2.11 qt) of oil from the oil pan into the container.
Dispose of the oil properly.
Remove the oil gauge from the tube. Remove any oil from the oil gauge. Reinstall the oil gauge. Remove the oil gauge from the tube.
Illustration 11 g01453783
(1) New "Full" label
The