SLEEVE 8N8886 - Caterpillar

Disassembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     3S-6224     Electric Hydraulic Pump Gp     1    
6V-3160 Double Acting Cylinder     1    
3H-0468 Puller Plate     4    
1U-9889 Crossblock     1    
3H-0469 Leg     2    
5F-7343 Bearing Puller Gp     1    
1A-1935 Full Nut     2    
1P-0510 Driver Gp     1    Start By:
Remove the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Remove".Note: The cooling system components and weights may vary depending on your arrangement.
Illustration 1 g01228698
Attach a suitable lifting device to fan assembly (1) . The weight of fan assembly (1) is approximately 225 kg (500 lb).
Illustration 2 g01228703
Loosen setscrews (3) . Remove bolts (2) .
Illustration 3 g01228704
Lower fan assembly (1) from retainer (4) .
Illustration 4 g01228705
Use Tooling (A) in order to remove retainer (4) .
Illustration 5 g01228708
Remove key (5) from fan shaft (6) . Remove fan assembly (1) .
Illustration 6 g01228723
Attach a suitable lifting device to fan shaft (6) , bearings (7) , and pulley (8) . The weight of fan shaft (6) , bearings (7) , and pulley (8) is approximately 70 kg (150 lb). Place fan shaft (6) , bearings (7) , and pulley (8) on suitable cribbing.
Illustration 7 g01228728
Loosen setscrew (10) . Attach a suitable lifting device to pulley (8) . The weight of pulley (8) is approximately 32 kg (70 lb). Remove bolts (9) and install bolts (9) at Locations (X) . Tighten the bolts in order to remove pulley (8) from the fan shaft. Remove pulley (8) and key (11) .
Illustration 8 g01228735
Illustration 9 g01228737
Note: Mark the location of bearings (7) for assembly.
Loosen setscrews (12) from bearings (7) . Remove bearings (7) from fan shaft (6) .