SLEEVE 8P0056 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Apply clean engine oil to the internal parts of the fuel priming pump.
Illustration 1 g01290018
Install a new O-ring seal (8) in the groove in pump cylinder (3) .
Illustration 2 g01290019
Install rotor (6) in pump cylinder (3). The drive grooves must be facing upward.
Illustration 3 g01290020
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install vanes (7) and the springs into rotor (6) .
Illustration 4 g01290021
Use Tooling (A) in order to install lip seal (5) in head (2). Install lip seal (5) with the lip toward the inside of the fuel priming pump.
Illustration 5 g01290022
Install shaft (4) through the lip seal in head (2) .
Illustration 6 g01290023
Note: The rotor is held in the center of the pump cylinder. The shaft in the head is off-center. Ensure that the pin in the shaft engages with one of the drive grooves in the rotor.Note: Ensure that the alignment marks match.
Install head (2) and the bolts on pump cylinder (3) .
Illustration 7 g00618482
Install handle (1) .
Turn handle (1). The fuel priming pump must rotate freely when the fuel priming pump is rotated by hand.End By: Install the fuel priming pump. Refer to Disassembly and Assembly, "Fuel Priming Pump - Install".