SLING-NYLON 1U8256 - Caterpillar

Introduction
Some of the components that are connected to the electronic control modules can be calibrated by using the Caterpillar® Electronic Technician (Cat ET).Calibrations are performed when directed by troubleshooting procedures or replacing a component within the calibrated system.The calibration of a component allows the ECM to determine the correct output level. The calibration also allows the ECM to determine the correct input signal of displacement.For more information on error codes that may occur during calibration refer to Testing and Adjusting, "Calibration Error Codes".Required Tools
Illustration 1 g03623456
Table 1
Required Tools
Tool Item Qty Part
Number Description
C 1 317-7484(1) Communication Adapter Gp
C1 1 370-4617 Cable As (USB PC Communication)
C2 1 317-7485 Communication Adapter III
C3 1 327-8981 Cable As (Data Link)
C4 1 317-7492 Cable As Wireless Radio
C5 1 JERD2129 Caterpillar Electronic Technician (Cat ET)
(1) Cat® Electronic Technician (ET) and Software CD, NETG5057 are required when using the communication adapter.Cat ET Calibration Screen
Illustration 2 g03749294
Typical Calibration screen
Machine ECM Calibrations
The following calibration can be performed to the Machine ECM:
Travel Pedal Calibration
Hydraulic Travel Motor Speed Calibration
Travel Pilot Valve Calibration
Main Pump Torque Calibration
Swing Angle Sensor Calibration
Tilt-Rotator System Calibration (If Equipped)To access the calibration procedures for the Machine ECM, establish the connections of the Cat ET to the machine. Navigate to the calibration screen by clicking "Service" on the tool bar and then clicking "Calibrations". Select the desired calibration procedure that is required. Click on the "Start" button at the bottom of the screen.Once the specific calibration is selected, the Cat ET will guide you through the calibration procedure.The Cat ET will list initial machine conditions that must be satisfied before the ECM will allow the calibration procedure to continue. Follow the specific instructions on the display in order to complete the calibration procedure.