SLIP JOINT GP 1618201 - Caterpillar

1618201 SLIP JOINT GP Caterpillar parts 834B, 836, 988F II

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1618201
161-8201
1618201

Weight: 146 pounds 66 kg.

Buy SLIP JOINT GP 1618201 Caterpillar genuine, new aftermarket tractor parts with delivery
LANDFILL COMPACTOR, WHEEL LOADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

SUPERWINCH 1618201 TALON 18SR WINCH 18000 LB

$2,856.13

27 Feb 2019
14700 Hundredths Pounds
SUPERWINCH: SUPERWINCH

SUPERWINCH 1618201 TALON 18SR WINCH 18000 LB

Superwinch 1618201 Talon 18.0SR, 12 VDC winch, 18,000 lb/8,165 kg capacity with hawse fairlead & synthetic rope

$1,799.99

18 May 2020
147.048328754[66.15] Poun
-: -

Superwinch 1618201 Talon 18.0SR, 12 VDC winch, 18,000 lb/8,165 kg capacity with hawse fairlead & synthetic rope
12 VDC winch, 18,000 lb capacity || Blue Anodized Aluminum Hawse || 90' of 3/8" Synthetic Rope with Heavy Duty Latched Hook and Rope Thimble || 15' ergonomically sealed handheld remote with coiled cord that retracts to 4' || "Dual Stop" 100% load holding brake design provides zero drag on cable

Number on catalog scheme: 3

Caterpillar 1618201 Parts scheme SLIP JOINT GP

For full view, you need register

Compatible equipment models: 1618201:

LANDFILL COMPACTOR 836

WHEEL DOZER 834B

WHEEL LOADER 988F II Caterpillar

Information:

Personal injury can result from air pressure.Personal injury can result without following proper procedure. When using pressure air, wear a protective face shield and protective clothing.The maximum air pressure for cleaning purposes must be reduced to 205 kPa (30 psi) when the air nozzle is deadheaded.
Pressurized air is the preferred method for removing loose debris. Direct the air in the opposite direction of the air flow. Hold the nozzle approximately 6 mm (0.25 inch) away from the fins. Slowly move the air nozzle in a direction that is parallel with the tubes. This movement will remove debris that is between the tubes.Pressurized water may also be used for cleaning. The maximum water pressure for cleaning purposes must be less than 275 kPa (40 psi). Use pressurized water in order to soften mud. Clean the core from both sides.Use a degreaser and steam for removal of oil and grease. Clean both sides of the core. Wash the core with detergent and hot water. Thoroughly rinse the core with clean water.After cleaning, start the engine and accelerate the engine to high idle rpm. This procedure will help in the removal of debris and drying of the core. Stop the engine. Use a light bulb behind the core in order to inspect the core for cleanliness. Repeat the cleaning, if necessary.Inspect the fins for damage. Bent fins may be opened with a “comb”. Inspect these items for good condition: welds, mounting brackets, air lines, connections, clamps and seals. Make repairs, if necessary.