SLIP JOINT GP 4700159 - Caterpillar

Illustration 1 g02394382
Position gear pump (21) and install bolts (20). Tighten bolts (20) to a torque of 55 10 N m (40 7 lb ft).
Illustration 2 g02394401
Install O-ring seal (19).
Illustration 3 g02454082
Position housing (18) and install bolts (17). Tighten bolts (17) to a torque of 55 10 N m (40 7 lb ft).
Install tube assembly (16). Tighten tube assembly (16) to a torque of 42 2 N m (31 2 lb ft).
Install tube assembly (15). Tighten tube assembly (15) to a torque of 172.5 7.5 N m (127 6 lb ft).
Illustration 4 g02454081
Install seal (14).
Illustration 5 g02380297
Apply Tooling (E) onto surface (X) and surface (Y) of the transmission housing and the torque converter housing.
Illustration 6 g02454077
Position oil pan (13) and install bolts (12). Tighten bolts (12) to a torque of 55 10 N m (40 7 lb ft).
Illustration 7 g02454076
Install screen (11) and magnetic filter (10).
Illustration 8 g02454058
Install O-ring seal (9), cover (8), and bolts (7). Tighten bolts (7) to a torque of 28 7 N m (21 5 lb ft).
Illustration 9 g02454024
Illustration 10 g02453439
Illustration 11 g02454022
Attach Tooling (B), Tooling (C), and a suitable lifting device onto transmission and torque converter (6). The weight of transmission and torque converter (6) is approximately 544 kg (1200 lb).
Remove transmission and torque converter (6) from Tooling (D).
Illustration 12 g02377316
Remove Tooling (A) from the transmission housing.
Illustration 13 g02454019
Install bracket (5).
Illustration 14 g02377717
If equipped with a rear PTO shaft, install bearing assembly (3) onto output shaft (4) and install retaining ring (2). Install bearing assembly output shaft (4) and bearing assembly (3). Install retaining ring (1).