SLUG 3T4215 - Caterpillar

Illustration 1 g01235068
Electronic Control Module (ECM)
Typical example
(1) ECM
(2) Auxiliary drive The flash file consists of the following items.
The flash file has all of the software and instructions for the ECM. Updating the flash file to a different version may cause some changes. Some of the characteristics of the engine operation may behave differently.
A control map defines the fuel rate, the timing, and other similar values. These values are defined for various operating conditions in order to achieve the optimum engine performance and fuel consumption. These values are programmed into the flash file at the factory.The ECM consists of the following items.
The ECM has a microprocessor that is used to perform computing functions. The microprocessor is necessary for the ECM to execute the following functions: governing, injection timing control, system diagnostics and data link communications. The microprocessor receives instructions from the software that is stored in the flash file.
The ECM has a permanent memory that is used to store programmable parameters and diagnostic codes.
Input circuits filter electrical noise from the sensor signals. Input circuits protect the internal circuits of the ECM from potentially damaging voltage levels.
Output circuits provide the high currents that are necessary to energize the injector solenoids, the lamps, and the relay.
Power circuits provide high voltage for the injector solenoids and clean stable electrical power for the internal circuits and the external sensors.The ECM monitors various systems on the engine. This is done in order to ensure safe operating conditions. Functions that are performed by the ECM include the following items:
Low engine oil pressure
High engine coolant temperature
Engine overspeed
Air inlet restriction
Engine fuel filter restriction
High exhaust inlet temperature to the turbocharger
Coolant flow
High crankcase pressure