SOCKET AS.-T27 1939199 - Caterpillar

Connect attachment chain (4) to the fork carriage on lift truck (9). Make sure that the chain is snug and does not interfere with lift truck lifting/lowering operation.
Improper connection of the attachment chain can damage tooling and/or lift truck components. Make sure that placement of the chain does not interfere with movement of the lift/lower mechanism on the lift truck.
Illustration 24 g02747140
(1) Support Bracket Assembly (9) Lift Truck (10) Front Suspension Strut (11) Spindle
Use lift truck (9) to lift support bracket assembly (1), front suspension strut (10), and spindle (11) into position on the machine.
Refer to appropriate disassembly/assembly service manual procedure to install hardware and attach suspension strut to frame of machine.
Illustration 25 g02747145
(2) RH Bracket Assembly (3) LH Bracket Assembly (11) Spindle
Once the front suspension strut is installed on the machine, remove hardware (dealer supplied) connecting bracket assemblies (2) and (3) to spindle (11) .
Illustration 26 g02747147
(1) Support Bracket Assembly (9) Lift Truck
Use lift truck (9) to lower support bracket assembly (1) and move away from the machine.Inspection/Cleaning Section
Inspection
Inspect prior to each use for nicks, burrs, dents, cracks, bends, or worn parts. If damage is found, discontinue use until inspected and released for use by an approved inspector at the dealership.
Illustration 27 g02747157
Inspect all welds and check for damaged or bent components.
Inspect threads in support bracket assembly (1) .
Inspect 1D-4709 Bolts (5) and 5P-8250 Washers (6). Replace any worn or damaged hardware.
Do not use unless load identification markings on support bracket assembly (1) are legible.
Illustration 28 g02747176
Do not use if attachment chain (4) is damaged or missing.
Illustration 29 g02747177
Do not use if either pivot lock pin assembly (8) is damaged or missing.
Have tools inspected annually by an approved dealership inspector.Cleaning
Clean the tooling using a non-solvent based cleaner.Storage
Store tooling indoors in a clean, dry location to prevent rust or corrosion.
Store the tool on level ground, laying flat to prevent falling.Tool Disposal
At the end of the tools operational life, destroy the tool and dispose of as scrap.Service Parts
Illustration 30 g02747178
Table 4
148-0357 Front Strut Handling Group - Service Parts    
Item     Part No     Support Bracket Assembly     Qty    
(1)     148-0336     Support Bracket Assembly     1    
(2)     148-0337     Right-Hand Bracket Assembly     1    
(3)     148-0338     Left-Hand Bracket Assembly     1    
(5)     1D-4709     Hex Head Bolt 0 1-8 x
76.2 mm (3.00 inch)     8    
(6)     5P-8250     Hard Washer
27.7 mm (1.09 inch) ID x
49.3 mm (1.94 inch) OD     8    
(8)     -     Pivot Lock Pin Assembly 1     2    
1McMaster Carr:
Sash Chain - Part No. 92692A150,
Clevis Pin - Part No. 98306A411,
Hairpin Clip - Part No. 98335A069