SOCKET AS 5259169 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Open the hood.
Illustration 1 g00815576
Remove four bolts (1) and move refrigerant condenser (2) out of the way.
Illustration 2 g00815577
Loosen clamps (4) and (9). Remove hose assemblies (5) and (7) from hydraulic oil cooler (3) .
Remove clamp (6) from hose assemblies (5) and (7) .
Remove two bolts (8) .
Illustration 3 g00815580
Remove four bolts (10) and remove hydraulic oil cooler (3) from the machine.Installation Procedure
Illustration 4 g00815580
Install hydraulic oil cooler (3) and four bolts (10) .
Illustration 5 g00815577
Install two bolts (8) .
Install clamp (6) on hose assemblies (5) and (7) .
Install hose assemblies (5) and (7) on hydraulic oil cooler (3) and tighten clamps (4) and (9) .
Illustration 6 g00815576
Install refrigerant condenser (2) and install four bolts (1) .