SOCKET 5316111 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Specifications
Table 1
Machine Test Parameters
Date Product or Component SN
Measurement Location Measurement Actual
Hydraulic oil temperature for test 50 °C (122 °F) Introduction
This procedure confirms that the neutral start switch is operating properly. Perform this test if the engine can be started while the propel lever is out of the NEUTRAL position. Perform this test if the engine cannot be started.Required Tools
Table 2
Required Tools
Tool Item Qty Part No Description
A 1 198-4240 Digital Pressure Indicator Gp
A1 1 198-4234 Digital Indicator
A2 2 198-4239 Pressure Sensor Gp0 - 41340 kPa (6000 psi)
A3 2 198-4236 Adapter Cable As
Table 3
Required Tools
Tool Item Qty Part No Description
B 1 349-4200 Thermometer Test Preparation
Drive the machine to a smooth, horizontal surface.
Illustration 1 g06182706
Move propel lever (1) to the NEUTRAL position.
Illustration 2 g06182711
Move parking brake switch (2) to the ON position.
Illustration 3 g06182714
Move throttle lever (3) to the LOW-IDLE position.
Operate the engine for at least 5 minutes.
Illustration 4 g06182717
Move engine start switch (4) to the OFF position.
Illustration 5 g06187560
Remove six screws (5), and tilt plate (6) forward.
Illustration 6 g06241615
Insert black spoon from Tool (B) to into pin"5" of connector (7). Insert red spoon from Tool (B) into pin"6" of the connector.
Connect Tool (B) to Tool (A).Test Procedure
Make sure propel lever (1) is in the NEUTRAL position.
Set Tool (A) to measure continuity. The circuit across the switch should be open. If the circuit across the switch is closed, replace the neutral switch, and retest the switch. If the circuit across the switch is open, go to the next step.
Move propel lever (1) into the reverse range. The circuit across the reverse switch should close when the propel lever is moved into the reverse range.
Move propel lever (1) into the NEUTRAL position. If the switch does not operate as described above, replace the neural switch, and retest the neutral switch. If the switch operates as described above, go to the next step.
Remove Tool (B) from neutral start switch connector (7).
Position cover (6), and install six screws (5).